ELECTROEROSION AND ELECTRIC SPARK WORKS

ELECTROEROSION AND ELECTRIC SPARK WORKS

ELECTROEROSION WORKS

ELECTROEROSION is a type of metal processing that is performed by EDM machines. Cutting a workpiece surface layer is produced under the influence of electric discharge at which the destruction of metal occurs at the place where it is needed. This type of work allows you to get items of various shapes with internal openings or passages.

ADVANTAGES:
  • • work with virtually any surface hardness.
  • • deformation of the surface of parts with small thickness completely excluded.
  • • cutting accuracy can reach from 0.01mm up to 0.005 mm
  • • complete absence of heat around the cutting zone when cutting crack-sensitive alloys

Thanks to own equipment our company is ready to carry out electroerosion works using the electrode of any complexity.

Bath dimensions: 730 * 530 * 300 mm

Rely on professionals!
Get a free consultation by phone: +7-812-332-83-94

ELECTROSPARKING WORKS:

Electrosparking is used to harden the surface layer of the metal. On the surface of the product a thin layer of metal or composite material is applied to improve the hardness, wear resistance, heat resistance and resistance to erosion.

At electrosparking pulsed spark discharges between the electrodes (the workpiece (anode) - the tool (cathode)) are being made. Electrosparking is made on our own electrospark machines which allow to obtain through holes of any cross-section, blind holes and holes and cavities with curvilinear axle, cut blanks from the flat sheets, perform circular and internal grinding.

The size of the rotating loop: 200 * 125 * 75 mm

Item size: 250 * 160 * 75 mm

Rely on professionals!
Get a free consultation by phone: +7-812-332-83-94

Vacancy